Fiber Transport

Radio Frequency over Fiber

REAL-TIME CLOCK with a backed-up static RAM to monitor and record internal RF levels and service data (i.e. laser lifetime)
TX – (remote RF reception, i.e. diversity antennas): the units can incorporate a digitally tuned filter (25 MHz movable band over 400-800 MHz)
TX – it can route RF through an external filter or to additional receiver (redundancy) to easily implement a failsafe configuration that can switch on a redundant receiver or transmitter if any fault is detected
TX – It automatically monitors RF levels and intervenes to avoid fiber saturation
RX – (RF transmission, i.e. single-frequency master/slave areas)
RX – It can route an IFB high power signal to transmit locally and send low power IFB carrier over fiber to slave units
RX – When it is working along with a MTK952MS in slave configuration, the fiber loss is automatically recovered and the units increase the gain so that the transmitter power equals the target level (measured with an power/SWR meter integrated into the MTK952MS)

OPTIX Series 3 is a high performance RF to fiber optic (RFoF) conversion system designed to facilitate the remote placement of wireless audio antennas.
Without any signal loss over the optical cable, the OPTIX system can extend the range of antenna placement up to several kilometers, eliminating the need for bulky and lossy coaxial cable runs.
Compatible across VHF, UHF, and the 900 MHz band, OPTIX Series 3 is compatible across any brand wireless audio system.